1967 Plymouth Barracuda .No motor or transmission. I was going to turn this into a big block 4-speed badass barracuda. however I have since falling in love with an old Coupe that's going to get the motor and transmission. I have installed a Ford 8.8 rear end and did the disc brake conversion on the front, however, front end will need new ball joints so the car is totally 5 by 4.5 inch lug pattern. I purchased a rotten New York Barracuda that had a good black interior with a rare front bench with fold-down armrest interior and other parts including vinyl top trim and an air conditioning Dash and heater and AC unit, I also have the non AC Dash. I have added a clutch pedal and a 4 speed hump. I used the 68 K member it was a 318 car. So it's pretty much ready for a small or big block and a 4 speed. I have completely replaced the trunk floor, both of the rear quarters, did rocker repair, replace the two front floorboards and fixed one rear floorboard so all of the hard fabrication is done, passenger front fender is repairable but probably should be replaced as well as the trunk lid there is two sets of interior trim and windows dressings, wheel well trim and 1968 Grill and headlights as well as the rear tail lights and panel, this will make a good beginning for a restomod, a race car or just a badass Cuda.I have all the glass but the windshield there's also two loaded doors that have all the hardware and glass in them. two extra hoods and trunk lid that are in fair condition |