Dodge Charger 1970

103900 USD

CAR DESCRIPTION FROM SELLER
Premier Pontiac Trans Am Dealers and Restoration 1970 Custom Dodge Charger R/T Roadster Selling out of private collection this stunning (Only 9,370 R/T’s produced in 1970, only 1 R/T Roadster exists) Body: The car is titled as a 1970 Charger, but was custom built with a 1968 grill and taillight panel, and 69 quarter panels and fenders. The rear of the car is 3 inches wider than stock - this was done by pulling the quarter panels out 1.5 inches on each side when they were installed. This allowed for an outer well tub, and a much larger rear tire without modifying the frame or the trunk - which appears almost completely stock. A larger rear spoiler was molded into the decklid and extended to the edge of the quarters, (all steel). A passenger side fuel filler cap was added and is fully functional - you can fuel up from either side of the car (or both if you are in a hurry). All the side glass has been eliminated, and the door window openings welded/closed off using steel, and smoothed over into the upper door panels. Door handles, locks, windshield wipers, and cowl vents were shaved. One opens the doors by reaching inside and using the inner door handles. The firewall was extended out to eliminate the wiper motor indentation, and completely smoothed over. Both front and rear bumpers have been smoothed, (no bolts), and tucked into the car. The subframes were connected with 2x2 square tubing, and 1 5/8 round tubing was used to create a "cradle" to support the car and eliminate any flex. You can jack up any corner of the car and still open the doors - it's that stiff!! There is NO top - this is not a convertible - it's a true roadster. The underside of this car was completely coated in silver bed liner. Everything under the car is detailed and painted to color match. The trunk is also coated in silver bed liner. Interior: The 1970 style interior was kept, but the color was changed to 1968 red. Legendary Auto Interiors created custom door panels without any window roller holes. They also created the red seat covers for the stock front and rear bench seats. Carpet is red marine grade. The floorboards were coated with bed liner, then we applied Dynamat Extreme, then carpet. The drain holes in the floor are still accessible if needed. The seat foams were covered in plastic before the seat covers were installed - this prevents the seats from soaking up any water should you happen to get it wet. The dash contains both radio and heater delete plates, no defrost vents, and has been painted matching red. The gauges are all rebuilt, with new electronic fuel, voltage, temperature, and oil pressure gauges in the stock location. The dash contains a new Rallye tach as well. The switch holes for the wiper and washer have been filled and painted over. There are no windshield wipers - there's no top so why bother. Engine/Trans/Rear-end: Engine is a Fuel Injected 440 with a mild cam. The Retrotek fuel injection system is designed to look like a Holley carb, and fit any 4150 intake manifold. It is fed by an electric fuel pump located near the fuel tank. It was not designed for tons of power, and it has not been dyno'd. Other than the cam, the only modifications to the engine are a new Weiand intake manifold and headers. The headers are ceramic coated with Performachrome - appears like chrome but won't discolor! Engine bay is charcoal, and the engine is a body-matching silver. Gases exit through custom 2.5 inch dual exhaust and Flowmaster 44 mufflers. All the exhaust is treated with heat-resistant paint. This car sounds very tough and runs very nice - starts every time! An aluminum radiator with a custom color-matched shroud keep things cool. The trans is a 727 automatic with a 3000 stall converter. Rearend is a 3.23 gear, non-posi from an E-body (a little narrower than the B-body rear), with new Moser axles. Tires/Wheels/Brakes: Wheels are custom Billet Specialties (17x6 front, 17x11 rear). Tires are 325/45-17 rear, and 235/50-17 front. Rear tires are M&H Racemaster Drag Radials, and look awesome from the side or rear. They completely fill the custom expanded wheel wells. The brakes are 4-wheel manual disc. The front brakes are 1973 A-body conversion, the rear are SSBC conversion. A Wilwood master cylinder controls pressure. Paint/Body: 70 Smoothed RT Door Scoops. The paint is a custom 2-tone Charcoal over Silver, with a 1/8 inch red pinstripe between them. The grill has been blacked out, with the emblems painted a matching body silver. The bumpers are also charcoal color matching all deck surfaces. All lights work, including the vacuum operated headlight doors! The taillights/brake lights are super bright LED (23 leds in each one)! Wiring/Plumbing: The wiring has been completely redone with a Painless Wiring harness. The fuse block is now located out of sight above the drivers left foot. All of the engine bay and front wiring has been hidden along the frame rail. All of the engine electronics (ballast resistor, alternator regulator, electronic ignition, starter relay) have been hidden under the battery tray. All of the car's plumbing (brake and fuel lines) are completely custom and brand new. This is a one of one, one of a kind, custom 68-70 Charger 440 R\T and it’s ready to roll. Decoded: E87 – 440-6HP D32 – Automatic Transmission HD 727 R11- Music Master AM Radio H6XW- White Vinyl Bucket seats w/black pad, carpet, console 000-Full door panels A01-Light package C16-Console with bucket seats C55-Bucket Seats G33-Left Hand Mirror J45-Hood Pins and Lanyards M21-Roof Drip Rail Moldings N41-Dual Exhaust N42-Chrome Exhaust Tips N85-Tach A62-Rallye Cluster Y05-Built to U.S. Specifications if interested in this one of a kind Dodge Charger please contact $95,000.00 OBO 1.305.412.5000 or email text: 1.786.218.1763 +1.305.412.5000 or email All sales are final. AS IS/ WHERE IS DISCLAIMER Please read all terms and conditions carefully. Notice to all buyers: Pleas e know that you can view, test drive, e mail and have the above vehicle inspected by a mechanic of your choice and at your expense before the end of the auction. Please understand, we are all human and we do make mistakes and this is a used vehicle but We will do our very best to describe in detail any and all vehicles. We will not be held accountable for errors or omissions in the description. This vehicle is being sold AS/IS WHERE IS with no guarantees. IT IS UNDERSTOOD THE VEHICLE WILL BE SOLD, AS IS WITH NO WARRANTY, EITHER WRITTEN OR IMPLIED, WE HAVE TRIED TO GIVE THE BEST DESCRIPTION OF THE CAR AT THIS TIME. All sales of cars are handled by CH AUTO CORP state local taxes apply to Florida residents only, paperwork, & transfer fees apply to all buyers and are not negotiable($350)

CAR DESCRIPTION FROM SELLER

Premier Pontiac Trans Am Dealers and Restoration 1970 Custom Dodge Charger R/T Roadster Selling out of private collection this stunning (Only 9,370 R/T’s produced in 1970, only 1 R/T Roadster exists) Body: The car is titled as a 1970 Charger, but was custom built with a 1968 grill and taillight panel, and 69 quarter panels and fenders. The rear of the car is 3 inches wider than stock - this was done by pulling the quarter panels out 1.5 inches on each side when they were installed. This allowed for an outer well tub, and a much larger rear tire without modifying the frame or the trunk - which appears almost completely stock. A larger rear spoiler was molded into the decklid and extended to the edge of the quarters, (all steel). A passenger side fuel filler cap was added and is fully functional - you can fuel up from either side of the car (or both if you are in a hurry). All the side glass has been eliminated, and the door window openings welded/closed off using steel, and smoothed over into the upper door panels. Door handles, locks, windshield wipers, and cowl vents were shaved. One opens the doors by reaching inside and using the inner door handles. The firewall was extended out to eliminate the wiper motor indentation, and completely smoothed over. Both front and rear bumpers have been smoothed, (no bolts), and tucked into the car. The subframes were connected with 2x2 square tubing, and 1 5/8 round tubing was used to create a "cradle" to support the car and eliminate any flex. You can jack up any corner of the car and still open the doors - it's that stiff!! There is NO top - this is not a convertible - it's a true roadster. The underside of this car was completely coated in silver bed liner. Everything under the car is detailed and painted to color match. The trunk is also coated in silver bed liner. Interior: The 1970 style interior was kept, but the color was changed to 1968 red. Legendary Auto Interiors created custom door panels without any window roller holes. They also created the red seat covers for the stock front and rear bench seats. Carpet is red marine grade. The floorboards were coated with bed liner, then we applied Dynamat Extreme, then carpet. The drain holes in the floor are still accessible if needed. The seat foams were covered in plastic before the seat covers were installed - this prevents the seats from soaking up any water should you happen to get it wet. The dash contains both radio and heater delete plates, no defrost vents, and has been painted matching red. The gauges are all rebuilt, with new electronic fuel, voltage, temperature, and oil pressure gauges in the stock location. The dash contains a new Rallye tach as well. The switch holes for the wiper and washer have been filled and painted over. There are no windshield wipers - there's no top so why bother. Engine/Trans/Rear-end: Engine is a Fuel Injected 440 with a mild cam. The Retrotek fuel injection system is designed to look like a Holley carb, and fit any 4150 intake manifold. It is fed by an electric fuel pump located near the fuel tank. It was not designed for tons of power, and it has not been dyno'd. Other than the cam, the only modifications to the engine are a new Weiand intake manifold and headers. The headers are ceramic coated with Performachrome - appears like chrome but won't discolor! Engine bay is charcoal, and the engine is a body-matching silver. Gases exit through custom 2.5 inch dual exhaust and Flowmaster 44 mufflers. All the exhaust is treated with heat-resistant paint. This car sounds very tough and runs very nice - starts every time! An aluminum radiator with a custom color-matched shroud keep things cool. The trans is a 727 automatic with a 3000 stall converter. Rearend is a 3.23 gear, non-posi from an E-body (a little narrower than the B-body rear), with new Moser axles. Tires/Wheels/Brakes: Wheels are custom Billet Specialties (17x6 front, 17x11 rear). Tires are 325/45-17 rear, and 235/50-17 front. Rear tires are M&H Racemaster Drag Radials, and look awesome from the side or rear. They completely fill the custom expanded wheel wells. The brakes are 4-wheel manual disc. The front brakes are 1973 A-body conversion, the rear are SSBC conversion. A Wilwood master cylinder controls pressure. Paint/Body: 70 Smoothed RT Door Scoops. The paint is a custom 2-tone Charcoal over Silver, with a 1/8 inch red pinstripe between them. The grill has been blacked out, with the emblems painted a matching body silver. The bumpers are also charcoal color matching all deck surfaces. All lights work, including the vacuum operated headlight doors! The taillights/brake lights are super bright LED (23 leds in each one)! Wiring/Plumbing: The wiring has been completely redone with a Painless Wiring harness. The fuse block is now located out of sight above the drivers left foot. All of the engine bay and front wiring has been hidden along the frame rail. All of the engine electronics (ballast resistor, alternator regulator, electronic ignition, starter relay) have been hidden under the battery tray. All of the car's plumbing (brake and fuel lines) are completely custom and brand new. This is a one of one, one of a kind, custom 68-70 Charger 440 R\T and it’s ready to roll. Decoded: E87 – 440-6HP D32 – Automatic Transmission HD 727 R11- Music Master AM Radio H6XW- White Vinyl Bucket seats w/black pad, carpet, console 000-Full door panels A01-Light package C16-Console with bucket seats C55-Bucket Seats G33-Left Hand Mirror J45-Hood Pins and Lanyards M21-Roof Drip Rail Moldings N41-Dual Exhaust N42-Chrome Exhaust Tips N85-Tach A62-Rallye Cluster Y05-Built to U.S. Specifications if interested in this one of a kind Dodge Charger please contact $95,000.00 OBO 1.305.412.5000 or email text: 1.786.218.1763 +1.305.412.5000 or email All sales are final. AS IS/ WHERE IS DISCLAIMER Please read all terms and conditions carefully. Notice to all buyers: Pleas e know that you can view, test drive, e mail and have the above vehicle inspected by a mechanic of your choice and at your expense before the end of the auction. Please understand, we are all human and we do make mistakes and this is a used vehicle but We will do our very best to describe in detail any and all vehicles. We will not be held accountable for errors or omissions in the description. This vehicle is being sold AS/IS WHERE IS with no guarantees. IT IS UNDERSTOOD THE VEHICLE WILL BE SOLD, AS IS WITH NO WARRANTY, EITHER WRITTEN OR IMPLIED, WE HAVE TRIED TO GIVE THE BEST DESCRIPTION OF THE CAR AT THIS TIME. All sales of cars are handled by CH AUTO CORP state local taxes apply to Florida residents only, paperwork, & transfer fees apply to all buyers and are not negotiable($350)

BASIC CAR INFORMATION
Price:	103900 USD
Make:	Dodge
Model:	Charger
Year:	1970
Mileage:	891 MI
Trim:	roadster
Engine:	V8
Transmission:	Automatic

CONTACT SELLER

Dodge Charger 1970

See also

1934 Chevrolet Classic

1965 Ford Mustang

1970 Chevrolet Nova

1959 Mercedes-Benz 200-Series